Alice:LabNotes/2008-9-14: Difference between revisions

From ZhangLabWiki
Jump to navigation Jump to search
(New page: ==extending probe length== PCR after circlehelper insertion: H2O 40ul SYBR green (50x) 0.4ul ...)
 
>Zsakura2
 
(6 intermediate revisions by 2 users not shown)
Line 16: Line 16:
  25C 2hr -> 4C
  25C 2hr -> 4C
  Purify with Qiaquick columns, and measure the concentration using Nanodrop to determine the amount of spacer needed.
  Purify with Qiaquick columns, and measure the concentration using Nanodrop to determine the amount of spacer needed.
  Nanodrop result:  
  Nanodrop result: 19.8ng/ul *30ul
 
TBU gel image of the steps:
[[Image:ZhangLab_2 2008-09-15 10hr 59min--1.jpg]]
The spacer had high concentration around 100ng/ul, and 3ul of the spacer was loaded onto the gel.
Therefore the concentration is too high, and the bands can not be distinguished.


==22K probe preparation using Ribo V6==
==22K probe preparation using Ribo V6==
   
   
  Add 40ul of KOH to the remaining product after DpnII, incubate at 94C for 1hr.
  Add 40ul of KOH to the remaining product after DpnII, incubate at 94C for 1hr.
The above TBU gel result showed no bands at all, which means that 94C is too high and broke up all the bonds.

Latest revision as of 19:00, 15 September 2008

extending probe length[edit]

PCR after circlehelper insertion:

H2O                                                40ul       
SYBR  green (50x)                                 0.4ul          
Forward primer AmpRV6.2_2(100uM)                  0.2ul          
Reverse primer AmpFV6.2_2(100uM)                  0.2ul
Taq master mix(2x)                                 50ul         
probe template (product after Exo I&III)           10ul

94 2min -> (94 30sec -> 55C 1min -> 72 45 sec)* 15 cycles -> 72C 5min -> 15C hold

T7 exonuclease digestion:

Add 2ul of T7 exonuclease to the PCR product
25C 2hr -> 4C
Purify with Qiaquick columns, and measure the concentration using Nanodrop to determine the amount of spacer needed.
Nanodrop result: 19.8ng/ul *30ul
TBU gel image of the steps:
File:ZhangLab 2 2008-09-15 10hr 59min--1.jpg
The spacer had high concentration around 100ng/ul, and 3ul of the spacer was loaded onto the gel. 
Therefore the concentration is too high, and the bands can not be distinguished.

22K probe preparation using Ribo V6[edit]

Add 40ul of KOH to the remaining product after DpnII, incubate at 94C for 1hr.
The above TBU gel result showed no bands at all, which means that 94C is too high and broke up all the bonds.