Daniel:Notebook/HiResChrPaint/2013-7-12: Difference between revisions

From ZhangLabWiki
Jump to navigation Jump to search
>Djacobse
No edit summary
>Djacobse
No edit summary
Line 19: Line 19:
|}
|}


Summary: '''A''':
Summary: '''A''': Optimal labeling ratio for ULS dyes is around 2%, or 1 in 50 bp.  This experiment was done on Alexa 488 so it should be directly applicable to my research.  '''B''': Increasing reaction time up to 1 hour should only improve labeling.  Optimal time is suggested around 15 minutes but I think 20-30 wouldn't be too bad either.  '''C''': Reaction ratio

Revision as of 18:08, 12 July 2013

S2 Probe Prep (Started 5/29/2013)

Back to Calendar

I've been performing some research on the ULS labeling system to see if I can get a good grasp on what's going on before
I try labeling again.  The most telling, I think, is some figures from a poster I got on Invitrogen's webstite.

Research Notes: ULS

A B
File:ULS-LabelingRatio.png File:ULS-ReactionDuration.png
C D
File:ULS-ReactionRatio.png File:ULS-ReactionTemp.png

Summary: A: Optimal labeling ratio for ULS dyes is around 2%, or 1 in 50 bp. This experiment was done on Alexa 488 so it should be directly applicable to my research. B: Increasing reaction time up to 1 hour should only improve labeling. Optimal time is suggested around 15 minutes but I think 20-30 wouldn't be too bad either. C: Reaction ratio