Alice:LabNotes/2008-3-13
Jump to navigation
Jump to search
Experiment 1: Padlock library preparation
Step 9:Page Denaturing Gel
1. Add 40 uL Novex TBE-Urea sample buffer (2x) for single stranded DNA to 40uL oligo mix. 2. Mix 0.5 uL Invitrogen 10bp ladder with 9.5 uL dH2O, 10uL 2x TBE-Urea sample buffer. 3. Denature the DNA with loading dye on thermalcycler 75C for 15 min, then quickly transfer to ice, wait for 1 min. 4. Use a 2D well denaturing gel, add 0.5x TBE buffer. Flush the wells very well to remove all urea. 6. Pre-run the gel for 10 min at 200V, load the samples into the wells, run at 200V for 30 min. 7. Stain gel with 5uL SYBR Gold in ~100 mL of TBE in clean tray. Place tray on an orbital shaker for ~5 min.
Note: the samples used to run is the gel is the remaining 2/3 (~20 uL).
File:ZhangLab 2 2008-03-13 17hr 56min.jpeg
Result: two bands were cut out from the gel since the gel doesn't seem to be very straight, and there were two bright bands close to the 80 - 90 ng ladder bands.
Step 9 continued: Purify the product
1. Prepare two gel shearing assemblies by placing a 0.5 mL tube within another 1.5 mL NON STICK tube. Use G20 needle to punch a small hole at the bottom of the 0.5 mL tube. You need two assemblies for each PAGE gel. 2.Cut out the correct band (85-92 nt in this case), chop the band into small slices, split into two half and transfer each half to one shearing assembly. 3. Centrifuge at top speed > 12000 rpm for 2 min to sheer the gel, remove the 0.5 mL tube. 4. Add 400 uL clean 1x TE buffer in the 1.5 mL tube. Tape the tubes on a vortexer, place the vortexer in 50C incubator, shake the tubes at low speed overnight. 5. transfer the gel mix to Nanosep columns, spin for 3 min at top speed. 6. transfer supernatant to 1.5 ml tube.