Matt:LabNotes/2017-6-1

From ZhangLabWiki
Revision as of 23:03, 2 June 2017 by >Mzcai (→‎Gel PCR)
Jump to navigation Jump to search

Image and Seq

http://arep.med.harvard.edu/polony/polony_protocols/pcr.htm http://arep.med.harvard.edu/polony/polony_protocols/sbe.htm

Cast 10% gels with primer

Prepare Beads

  1. Prepare 50ml Dynabeads buffer: 20ml 5M NaCl + 100ul 0.5M EDTA + 125ul 4M Tris-HCl + 29.775ml H2O
    • 2M NaCl, 1mM EDTA, 10mM Tris-HCl
  2. Do 2 tubes, 1 for BarcodeV1 and 1 for BarcodeV3:
  3. Add 1ul Dynabeads MyOne Streptavidin C1 beads to 100ul buffer
  4. Vortex
  5. Pull down 1min on magnet
  6. Remove supernatant
  7. Combined 15ul buffer with 15ul amplicon
    • BarcUv1 240nM (dsDNA PCR product with Uracil prepared by Dan 5.5.2017)
    • BarcUv3 220nM (dsDNA PCR product with Uracil prepared by Dan 5.5.2017)
  8. Add to beads, pipette mix, and incubate 15min at room temp
  9. Pull down
  10. Wash twice with 100ul buffer (mix off magnet, and then pull down on magnet)
  11. Bring volume to 40ul with H2O

Gel PCR

 Prepare diffuse-in mix while allowing slides to dry.  You don't want the slides to over-dry, though.  You will observe a thin, shrinking film of liquid on the surface of each gel.  Generally, we try to add the diffuse-in mix within 5 minutes or so of this shrinking film's disappearance.  This generally means about 30 minutes of drying. 
  1. Let gel slide dry in AirClean hood for 30min
  2. Prepare 25ul PCR mix per gel
    • 2.5ul 5uM Primer2
    • 12.5ul KAPA SYBR FAST MM
    • 10ul beads (1:1 mix of v1 and v3)
  3. Pipet 25ul onto center of gel
  4. Apply 18x30mm cover slip
  5. Apply an orange SecureSeal chamber
  6. Fill chamber with mineral oil and seal holes with stickies.
  7. Slide PCR on Biorad thermocycler
 94C 3min -> (94C 1min30sec -> 55C 1min -> 72C 2min) x 15 -> 72C 4min -> 4C hold
  1. Place directly on Olympus with GFP/FITC filter