Jeff:LabNotes/Microbiome/2011-1-21

From ZhangLabWiki
Jump to navigation Jump to search

In well MDA using e coli cells[edit]

Try higher conc. of agarose and solidify after each step with a stringent washing procedure

  • Prior to beginning, create NS and ALS buffers
  • ALS Buffer: 82 uL H20, 10 uL 1M DTT, 8 uL 5 M KOH
  • NS Buffer: 3 mL H2O, 3 mL 2M Tris, 4 mL 1N HCL
  • Make sure an even mix of the 2 buffers has a pH of 7-8 before moving on
  • Clean down hood with ethanol and UV tubes, arrays, gaskets, etc for 10 min
  • Use e coli with initial conc. 10^6 cell/uL
  • Create the following mix: 38uL .5% agarose, 12 uL e coli, 6 uL C12 N6 labeled beads, 4 uL 3% BSA
  • Create another mix with agarose instead of e coli and use as NTC
  • Add 3 uL of mix to square and let settle for 5 min
  • Create a lysis mix: 2uL lysozyme, 2 uL NaCl, 2 uL Tris
  • Add 3 uL of lysis mix to square with cells and let sit for 15 min at rt
  • Add 3 uL of ALS buffer to each and sit for 3 min
  • Create the following master mix while waiting: 15 uL 200 uM N6 primer, 7.5 uL 10x buffer, 17.1 uL H2O, 2.4 uL 25 nM dNTP, 3 uL Phi 29. This master mix is enough for 3 reactions
  • After 3 min, add 3 uL of NS buffer to each square to neutralize
  • Add 16 uL of master mix to each. Incubate at 30 C for 4 hr then 85 C for 3 min, and 4C for 10 min.

Hybridization and Washing

  • Remove secure seal
  • Create following mix: 2 uL 20x SSC, 28 uL Formamide, 10 uL H20 and add 20 uL to each array. UV mix for 10 min. Heat to 70 C. Seal array tightly with new secure seal gasket and incubate at 70 C for 15 min (transfer in pipette tip box). Then 4 C for 10 min
  • UV clean water, Wash 1E, and SSPE for 10 min
  • Wash arrays for 3 min with 20 uL H20 on shaker (transfer and keep in pipette box while shaking)
  • Wash arrays twice with 20 uL Wash 1E for 4 min on shaker
  • Create following mix: 199 uL 6x SSPE with .01% Triton 100 X and 1 uL Cy5 probe
  • Add 20 uL to each square. Cover with new secure seal gasket and incubate at 94 C for 2 min then 54 C for 15 min (use same sterile techniques) and 4 C for 10 min
  • Remove excess solution and wash with 20 uL H2O for 3 min
  • Wash arrays once with 20 uL Wash 1E twice for 4 min on shaker

Results

Amplification was successful. THere is a lot less background.

File:1-21-11 1.jpeg File:1-21-11 2.jpeg Template

File:1-21-11 3.jpeg File:1-21-11 4.jpeg NTC